Fleet-engineers INS-02021 Bedienungsanleitung PDF herunterladen (Seite 1)

1. Position the two ISO-BLOX

between the fender and mount-

ing tube. Make sure the fender, ISO-BLOX

and mounting

tube are all in the desired location to spot the mounting

holes.

Installation Sheet Part Number INS-02021 • 2/02 •Rev. A-8/02 • Rev B-10/06 • RevC-12/10 • Rev. D 5/13

Each X-FLEX

ISO-BLOX

System Includes:







Self Locking Screws









ISO-BLOX

Installation Sheet

#INS-02021

NOTE: These instructions for installation are intended to be a

general guide to help the installer. Because of the large number of

possible mounting conﬁgurations, the installer is responsible for

the ultimate installation design. Any modiﬁcations to the product

are at the discretion, responsibility and risk of the installer.

Note: The desired position for the X-FLEX

mounts

will vary from one installation to another. This is best

determined with the help of the instructions from the

fender manufacturer.

If mounting instructions from the fender manufacturer

are unavailable, the X-FLEX

mounts should be located

approximately 5”-6” in from the sides of the fender.

When using X-FLEX

ISO-BLOX

with an end mount on

a half tandem, locate no more than 18” from the end of

the fender.

The ISO-BLOX

™

is a vibration isolation

system designed for use under the

fender to secure a 1-7/8” tube mount

in ﬂat or center mounted applications.

Assembly Instructions

         

bit, spot where the mounting holes will be in the fender by

running the drill bit through the threaded bushings in the ISO-

BLOX

. Be careful not to damage the threaded bushings.

Note: Running the drill in reverse is a safe way to do

this!

     

using the spot marks for location.

        



head screws.

 

plates to the ISO-BLOX



and lock washers.

 

if using a different style of fender mount, use manufactures

directions.

 

and any other mounts are installed and

the fender is in the desired location, tighten all screws and

bolts on the ISO-BLOX



5/16” bolts and screws torque to 156 in. lbs. or 13 ft. lbs.



OPTIONAL: -





Xtend-a-pads between

the ISO-BLOX

and the fender. Order



ISO-BLOX 1

Inhaltsverzeichnis

Seite 1 - ISO-BLOX

1. Position the two ISO-BLOX® between the fender and mount-ing tube. Make sure the fender, ISO-BLOX® and mounting tube are all in the desired locatio

Kommentare zu diesen Handbüchern

Keine Kommentare

Fleet-engineers INS-02021 Bedienungsanleitung Seite 1

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Fleet-engineers INS-02021 herunter. Fleet Engineers INS-02021 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Fleet-engineers INS-02021 Bedienungsanleitung Seite 1

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Fleet-engineers INS-02021 herunter. Fleet Engineers INS-02021 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Fleet-engineers INS-02021